Sliding glass doors
Single hung
Double hung
Horizontal roller
Casement
Bay & bow
Entry doors
Impact garage doors
PGT
CGIFree in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Get your free estimateTrusted Window Installation for Boulder City Homeowners
Window installation in Boulder City, NV runs $420 to $1,850 per opening for most homes, depending on window type, glass package, and whether the frame is being reframed. Boulder City sits at roughly 2,500 feet in the Mojave, which means your windows take a harder sun load and a wider swing between summer highs and winter nights than anything the original 1970s and 1980s glass was built to handle. Our technicians have up to 18 years of experience setting and sealing windows in this climate, and every job is backed by our 90-Day Done Right Promise. Call (844) 560-0350 to schedule your free estimate; a live person answers every call, day or night.
What Our Window Installation Service Includes
Every opening in your home gets measured twice before we quote, and the manufacturer lines are laid out side by side on paper so you see exactly what you’re buying. Here’s how each window type is handled.
Single & Double Hung Windows
Hung windows slide up and down in the frame, and the double-hung version tilts both sashes in for cleaning from inside the house. They’re the most common replacement in Boulder City’s older single-story neighborhoods, where original aluminum sliders have lost their weatherstripping and rattle in a spring wind. We set them plumb and square, shim at the jamb rather than the sill, and foam the perimeter so desert dust doesn’t find a path in around the frame.

Horizontal Roller Windows
These are the wide sliders you see across the back of most Boulder City ranch homes, and they’re the window that fails first here. Grit works into the track, the rollers flat-spot, and the sash starts dragging or sealing crooked against the frame. We replace the whole unit rather than fighting a worn track, and we set the new one with a fresh weep system so monsoon rain that blows sideways off the McCullough Range drains out instead of pooling on the sill.

3-Panel Sliding (3-Lite Roller) Windows
A three-panel slider gives you a wide opening for a big wall while keeping the glass count manageable. They suit the long living-room walls in Boulder City homes that face the lake and want the view without a fixed pane you can’t open. We check the header for deflection before we order, because a sagging header over a 9-foot opening will bind a new slider just as fast as it bound the old one.

Casement Windows
Casements crank open on a hinge and seal tighter than any slider when they’re closed, which matters on the west side of a Boulder City house taking afternoon sun. They also catch the evening breeze off the lake when the day finally breaks. We check the crank mechanism and hinge alignment on every unit before it goes in the opening, because a casement that’s slightly out of true will leak air at the corners.
Awning & Hopper Windows
Awning windows hinge at the top and push out, and hoppers hinge at the bottom and tip in. Both let you vent a bathroom, laundry, or kitchen without leaving an opening a desert downpour can blow into. In Boulder City we often pair them with a fixed panel above a door or over a kitchen sink, and we size the rough opening carefully so the frame lands flush with the surrounding stucco.
Picture & Fixed Windows
A picture window doesn’t open. It’s there for the view and the daylight, and it’s the cheapest glass per square foot you can put in a wall. On the lake-facing walls of Boulder City homes we spec these with a low-E coating tuned for our sun angle, and we seal them with a continuous backer rod and sealant joint rather than a thin bead that cracks the first summer.
Bay, bow, and garden windows are also part of what we install, and they get the same treatment: measure twice, set true, seal the perimeter, and register both manufacturer warranty layers in writing before we leave.
Styles & brands we work with
- Single hung
- Double hung
- Horizontal roller
- Casement
- Bay & bow
- Sliding glass doors
- Entry doors
- Impact garage doors
- PGT
- CGI
Brands We Service for Window Installation
We’re an authorized installer for more than a dozen manufacturer lines, including Andersen, Pella, Marvin, Milgard, PGT, CGI, and ES Windows. That range matters when a homeowner wants a specific look, a specific U-factor, or a specific warranty term, because we can put two or three of them side by side on paper instead of steering you toward whatever’s easiest to order. With PGT and CGI, we’ve learned where their vinyl frames and impact-rated glass hold up best in Southern Nevada sun and which configurations seal tightest against wind-driven dust; we know how their units want to be flashed at the sill. With ES Windows, we know their impact and energy lines well enough to tell you which one actually earns its price in our climate. Whether you have PGT, CGI, ES Windows, or any other make, we can help.
What we don’t do is quote a brand we haven’t set with our own hands. When you ask about a line, you’ll get straight answers about where it wears out, how it’s warranted, and whether it’s the right fit for a Boulder City exposure. If you’re replacing windows elsewhere in the valley, our window installation in Henderson page covers the same process for that market.
Signs You Need Window Installation Right Now
- Fogging between the panes. That white haze is a failed seal on the insulated glass unit, and the argon that was supposed to insulate your home is gone. It won’t clear on its own, and the efficiency you paid for goes with it.
- Daylight around the frame. If you can see light at the edges with the window shut, air and dust are coming through the same gap. On older Boulder City homes this usually means the original sealant has cracked and the frame has shifted, not just that the weatherstripping is tired.
- Sticking or binding sashes. A window that won’t slide or crank freely is often a sign the frame is out of square or the header has moved. Forcing it wears the rollers and hinges faster and can crack the glass.
- Condensation on the inside of the glass in winter. Interior condensation points to a glass package that isn’t keeping the cold out and warm, moist air off the pane. It’s also the first sign you’ll see before mold starts in the surrounding drywall.
- Rattling in a hard wind. Windows that shake in a gust are losing their seal to the wall, which is a sealing and setting problem as much as a glass problem. Left alone, it widens into water intrusion at the sill.
None of these are a reason to panic. But if two or three of them are happening at once, the window is telling you it’s past repair, and a fresh unit is usually cheaper over a decade than patching the same one twice.
Our Window Installation Process – Step by Step
- 1
Measure every opening, twice. We check width and height at three points on each opening and compare them, because an out-of-square frame is the root cause of most problems a homeowner inherits from a previous install. We look at the header, the sill, and the existing flashing before we write a line.
- 2
Side-by-side quotes on paper. We lay out the manufacturer lines that fit your openings, with the warranty durations stated for each, so you compare like for like. There’s no high-pressure close, no surprise line items, and no reason not to take the sheet to your kitchen table and think it over.
- 3
Set, shim, and square. On install day we remove the old unit, inspect the rough opening for rot or damage, and set the new window plumb, level, and square. We shim at the jamb and not the sill, foam the perimeter, and check the unit with a level before it’s sealed in.
- 4
Seal and finish the exterior. Fresh flashing, backer rod, and a properly tooled sealant joint keep monsoon rain and desert dust out. We match the existing trim as closely as the opening allows so the window looks like it belongs in the wall, not added after.
- 5
Walk the job and register the warranties. We open and close every window, check the locks and cranks, and walk you through the work before we pack up. Then we register both manufacturer warranty layers in writing, durations stated, before the truck leaves the driveway.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Window Installation Cost in Boulder City?
Most Boulder City window installation falls in the $420 to $1,850 per-window range. A single-hung vinyl replacement in a standard opening typically runs $420 to $720 installed. A horizontal roller or a three-panel slider in a wide living-room wall runs $750 to $1,450 depending on width and glass package. A bay or bow window, which needs framing and a built-up head, runs $1,900 to $4,200.
| Window type | Typical installed range in Boulder City |
|---|---|
| Single & double hung | $420 – $720 |
| Horizontal roller | $550 – $950 |
| 3-panel sliding (3-lite) | $1,100 – $1,850 |
| Casement | $600 – $1,050 |
| Awning & hopper | $450 – $800 |
| Picture & fixed | $425 – $850 |
| Bay & bow | $1,900 – $4,200 |
Two things move the price most in our market: the glass package and what we find once the old unit comes out. A low-E coating tuned for our sun angle and a tempered pane in a door-adjacent opening add to the number, and both earn it back over time. Rot or a damaged rough opening adds labor. To avoid overpaying, get the quote in writing with the window model named and the warranty durations stated. That’s what our free estimate is: a written, line-item quote with the manufacturer lines side by side on paper, upfront pricing, and no change orders. Call (844) 560-0350 and a live person will set it up.
Window Installation Near Boulder City – Our Service Area
We install windows across Boulder City, from the lake side to the older blocks near the historic district. We also work just down the valley in Henderson and the smaller communities around it, and we serve window installation in Whitney. If your home is elsewhere in Clark County, reach out anyway. We’ll tell you honestly when we can be there, and we show up when we say we will. Call (844) 560-0350 to check your address and schedule a free estimate. You can also read more about our work on our home page.
Serving Boulder City, NV – Our Local Coverage Area
We serve Boulder City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Window Installation in Boulder City
Window installation is the removal of an existing window unit and the setting of a new one in the rough opening, sealed and squared so it performs as it was engineered to. It covers measuring the opening, ordering the right unit, setting it plumb and level, flashing and sealing the exterior, and finishing the interior trim. At TruePane Windows & Doors Boulder City we do all of it in one visit on most jobs, with background-checked, uniformed technicians. Call (844) 560-0350 to schedule your free estimate.
Most single windows take about two to three hours, and a whole-house job of ten to fifteen windows usually runs two to three days. The variable is what we find when the old unit comes out: sound framing and intact flashing move fast, and rot or a damaged rough opening adds time. We’ll give you a realistic schedule in the estimate and won’t leave you with a half-open wall overnight. Call (844) 560-0350 for an exact timeline.
Window installation in Boulder City typically runs $420 to $1,850 per window, with large sliders and bay or bow windows at the top of that range. Glass package, window type, and the condition of the opening are the main factors. We quote manufacturer lines side by side on paper so you can compare the warranty durations directly. Call (844) 560-0350 and we’ll set up a free written estimate.
Yes. We install PGT, CGI, ES Windows, and more than a dozen other manufacturer lines, and we’re authorized to install them. We know where each brand’s frames and glass hold up best in our Southern Nevada sun and wind, and we’ll tell you which line fits your openings rather than steering you toward a favorite. Both warranty layers are registered in writing before we leave. Call (844) 560-0350 to talk through the options.
Clear the furniture and wall hangings away from each window about three feet, and take down curtains and blinds before we arrive. Our technicians cover floors and set down drop cloths, so you don’t need to move anything heavy yourself. Have a parking spot available near the work area and let us know about pets so we can keep doors secured. Call (844) 560-0350 if you have questions about your specific setup.
Every job carries our 90-Day Done Right Promise: if it isn’t done right, we make it right, with no paperwork and no arguing. Under The Keystone Standard we register both manufacturer warranty layers in writing, durations stated, before the truck leaves the driveway. That way none of your coverage is left unregistered or voided by an installation error. Call (844) 560-0350 to ask what a specific window’s warranty covers.
Yes. A live person answers every call, 24 hours a day, 7 days a week, not a voicemail tree or a callback form. We’re a company rooted in this community and we plan to be here in thirty years, so the phone stays answered. Call (844) 560-0350 any time to schedule your free estimate. Standing offers include $50 off any repair over $250, an $89 seasonal tune-up, and a permanent 5% discount for seniors and veterans.
Schedule Your Window Installation Service in Boulder City Today
Whether it’s one fogged slider or a whole house of tired 1980s glass, we’ll measure twice, quote it in writing, and set it true. Call TruePane Windows & Doors at (844) 560-0350 for a free, no-obligation estimate. A live person answers every call, day or night. We’ll be there when we say, and if the pane isn’t true, the job isn’t done.
Written by the team at TruePane Windows & Doors.